Разработка технологии изготовления зубопротезных дисков из сплавов золота и исследование их свойств

Loading...
Thumbnail Image

item.page.other-contributor

item.page.advisors

item.page.editors

Date

Publisher

item.page.issn

item.page.isbn

item.page.depon

item.page.diss

Journal Title

Journal ISSN

Volume Title

item.page.title-alternative

Development of manufacturing techniques of dentoprosthetic disks from gold alloys and the research of their properties

Abstract

При работе с драгоценными металлами необходим поиск таких способов обработки, при которых безвозврат­ные потери драгоценного металла будут минимальными. В связи с этим необходимо исследовать основные физико-механические свойства драгоценных металлов: прочность, твердость, упругость, пластичность и их коррозионную стойкость; определить влияние температуры обработки на механические характеристики полученных слитков драг­металла. Кроме того, необходимо знать физико-химические свойства металлов, входящих в состав сплава, возмож­ности воздействия на них методами обработки металлов давлением, причем знание таких свойств особенно важно при изготовлении зубопротезных дисков. В результате исследований установлено, что при прокатке полосы сплава золота 900-й пробы исходной толщи­ны от 4 до 0,55 мм происходит вытягивание зерен в направлении прокатки, предел прочности сплава ЗлСрМ 900-40 увеличивается почти в 2 раза и отжиг при температуре 650 °С в течение 3 мин полностью восстанавливает пластиче­ские свойства сплава.

item.page.description-other

Searching of such ways of processing at which irrevocable losses of precious metal will be minimum is necessary during the work with precious metals. In this regard it is necessary to investigate the main physico-mechanical properties of precious metals: durability, hardness, elasticity, plasticity and their rust resistance; to define temperature effect of processing on mechanical characteristics of the obtained precious metal ingots. Besides it is necessary to know physical and chemical properties of the metals which are a part of alloy, their workability by methods of metal forming, and knowledge of such properties is especially important at manufacture of dentoprosthetic disks. As a result of researches it is established that when rolling a strip of gold alloy of 900 fineness from initial thickness 4 mm to 0.55 mm, there is an extraction of grains in the direction of rolling; ultimate strength of alloy of AuAgCu 900-40 increases almost twice. Further annealing at temperature of 650 °C for 3 minutes completely restores plastic properties of the alloy.

Description

Citation

Клубович, В. В. Разработка технологии изготовления зубопротезных дисков из сплавов золота и исследование их свойств = Development of manufacturing techniques of dentoprosthetic disks from gold alloys and the research of their properties / В. В. Клубович, М. М. Кулак, Е. В. Хрущев // Весцi Нацыянальнай акадэмii навук Беларусi. – 2017. – № 1. – С. 52-58.

Endorsement

Review

Supplemented By

Referenced By